Blog menu

Printing with Safeprint onto Paper and Fabric

Printing with Safeprint onto Paper and Fabric

Safeprint is a thin piece of polystyrene block that is a quick and easy way of making a relief print. You don’t need lino tools to carve it, just a pencil! For this reason, it’s brilliant to use with children and in schools. If you haven’t tried it before, give it a go – it’s so quick!

Start by tracing your image or drawing. We used this photograph of a bear. You’ll need to use a very soft pencil or graphite stick: a 4B, 6B or 9B will be perfect.

Flip over your drawing and place it face down on your piece of Safeprint. Use a pencil on its side to rub the tracing paper, transferring the image to the Safeprint block. Make sure to use only the side of the pencil and press softly so not to make any dents in the Safeprint – these could show in your prints.

You should have a faint drawing on your Safeprint. You can use this as a guideline for your block.

You’ll need two pencils for carving your block, the first of which is a hard, sharp pencil – sharpen an HB (or H, 2H etc) to within an inch of its life. You want it to be sharp and scratchy for breaking the surface of the Safeprint without tearing or dragging.

The second pencil you will need is a blunt one – the kind that’s too blunt to draw with and would get you into trouble at school. You want a nicely rounded end to press into the block and squash it.

This part works just like lino printing: you’re taking away the areas that you want to be left unprinted. This bear is going to be printed in a dark colour onto a light background. This means that I am taking away the parts that I want to remain the background colour after it’s printed.

Use your blunt pencil to push down any large areas that you don’t want to print, just like carving away a piece of lino. The blunt, rounded end will squash the polystyrene down so that it wont pick up any ink.

Use your sharp pencil to scratch in any lines and details. The sharp point will break through the surface of the polystyrene without tearing it. For thicker lines, break through the surface first with a sharp pencil and then go over them with the blunt pencil to widen the lines.

Continue to draw all over your block with the sharp and blunt pencils, pushing or scratching away areas that you don’t want to print.

If your design is a shape like this one, use a scalpel to cut out your block. This is the only part that isn’t suitable for children, especially as the knife needs to be really sharp so that it slices through the block rather than tearing it.

When you have cut out your block you are ready to ink it up. Mix up a colour of your choice on an inking tray or slab. For printing onto paper, we are using Caligo safe wash relief inks but for a water based alternative you can use our Adigraf or Shmincke range.

 

Roll out an area of your ink onto your tray or slab. You don’t want the ink to be squelchy. You want an even, suede-like texture that makes a zzz sound
with your roller. 

Ink up your roller in this patch of ink and gently roll it onto your block. Make sure you cover all the areas of the block but try not to go over it too many times as the roller could end up lifting off the ink instead of putting it on.

Place your block face down on the paper. Use a clean roller to roll all over the back of the block. You may need to hold it still with your free hand.

Peel off your block to reveal your print!

To print onto fabric, remove the excess paper ink off your block by pressing it onto some scrap paper a few times. For printing onto fabric we are using Speedball Block Printing Inks for Fabric which are water-based and easy to use.

Roll out the ink and print using exactly the same method onto your fabric!

For this project you will need:

 

 

Back to blog